Vanity Light: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH sides.
The procedures listed below are for the LH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE VANITY LIGHT ASSEMBLY
1. Using a screwdriver, pry out the vanity light.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Removing Vanity Light Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Detach the 2 claws and vanity light.
  
  Fig 2: Attaching Claws For Installing Vanity Light Lens
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VANITY LIGHT BULB
1. Remove the light bulb from the vanity light.
  
  Fig 3: Identifying Vanity Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002