Vanity Light: Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT VISOR ASSEMBLY

Remove the visor assembly.

Inspect vanity light switch.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Condition	Specified Condition
1 (L) - 2 (B)	Visor raise	10 kΩ or higher
	Visor lower and mirror cover open	Below 1 Ω
	Visor lower and mirror cover close	10 kΩ or higher

Fig 1: Inspecting Visor Assembly

If the result is not as specified, replace the visor assembly.