Rear Door Courtesy Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH sides.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (see STANDARD BOLT ).

INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
1. Connect the connector.
2. Install the switch with the bolt.
  
  Fig 1: Identifying Rear Door Courtesy Light Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL