Luggage Room Light: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BACK DOOR COURTESY LIGHT ASSEMBLY
1. Install the bulb to the light.
  
  Fig 1: Identifying Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 4 claws to install the light shade.
  
  Fig 2: Identifying Light Shade Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the light as shown in the illustration.
  
  Fig 3: Installing Back Door Courtesy Light
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BACK DOOR TRIM BOARD (See REASSEMBLY )
INSTALL BACK DOOR SIDE GARNISH RH (See REASSEMBLY )
INSTALL BACK DOOR SIDE GARNISH LH (See REASSEMBLY )
INSTALL BACK DOOR CENTER GARNISH (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL