LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Lighting) >> License Plate Light Assembly >> Installation

License Plate Light Assembly: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL LICENSE PLATE LIGHT ASSEMBLY 
    1. Install the light as shown in the illustration.
      Fig 1: Installing License Plate Light Assembly
      G05586014Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL BACK DOOR LOWER OUTSIDE GARNISH SUB-ASSEMBLY  (See REASSEMBLY )
  3. INSTALL BACK DOOR TRIM BOARD  (See REASSEMBLY )
  4. INSTALL BACK DOOR SIDE GARNISH RH  (See REASSEMBLY )
  5. INSTALL BACK DOOR SIDE GARNISH LH  (See REASSEMBLY )
  6. INSTALL BACK DOOR CENTER GARNISH  (See REASSEMBLY )
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL