On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT DAY TIME RUNNING LIGHT RELAY

Remove the No. 2 relay, No. 3 relay and No. 4 relay from the engine room No. 2 relay block.

Measure the resistance of the relays.

Standard resistance:

No. 2, No. 4

DAY TIME RUNNING LIGHT RELAY - NO. 2, NO. 4

Tester Connection	Specified Condition
3 - 5	10 kΩ or higher
3 - 5	Below 1 Ω (Battery voltage applied to terminals 1 and 2)

No. 3

DAY TIME RUNNING LIGHT RELAY - NO. 3

Tester Connection	Specified Condition
4 - 5	Below 1 Ω
4 - 5	10 kΩ or higher (Battery voltage applied to terminals 1 and 2)
3 - 5	Below 1 Ω
3 - 5	10 kΩ or higher (Battery voltage applied to terminals 1 and 2)

If the result is not as specified, replace the relay.

Fig 1: Inspecting Day Time Running Light Relay