On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT BRK RELAY

Remove the BRK relay from the engine room No. 1 relay block.

Measure the resistance of the relay.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Specified Condition
3 - 4	Below 1 Ω
3 - 4	10 kΩ or higher (Battery voltage applied to terminals 1 and 2)
3 - 5	10 kΩ or higher
3 - 5	Below 1 Ω (Battery voltage applied to terminals 1 and 2)

Fig 1: Inspecting BRK Relay

If the result is not as specified, replace the relay.