LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Supplemental Restraint System) >> Steering Pad >> Installation

Steering Pad: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION  ).
  1. INSTALL STEERING PAD ASSEMBLY 
    1. Support the steering pad with one hand as shown in the illustration.
      Fig 1: Identifying Airbag Connectors
      G05585769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 2 airbag connectors.
      NOTE: When handling the airbag connector, do not damage the airbag wire harness.
    3. Connect the horn connector.
    4. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
    5. Using a T30 "TORX" driver, install the 2 screws.

      Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf) 

      Fig 2: Identifying Steering Pad Assembly Torx Screws
      G05585770Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  3. INSPECT STEERING PAD ASSEMBLY 
    1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
    2. Check that the horn sounds.
  4. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see PROBLEM SYMPTOMS TABLE  ).
scientia non olet · About LEMON Manuals