Spiral Cable: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION ).

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE STEERING PAD ASSEMBLY (See REMOVAL )
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
REMOVE STEERING WHEEL ASSEMBLY (See REMOVAL )
REMOVE STEERING COLUMN COVER (LOWER) (See REMOVAL )
REMOVE SPIRAL CABLE SUB-ASSEMBLY
1. Rise the steering column cover (upper).
  NOTE: When handling the airbag connector, do not damage the airbag wire harness.
  
  Fig 1: Identifying Steering Column Cover (Upper)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Detach the 4 clips and remove the column cover (upper).
  
  Fig 2: Identifying Column Cover (Upper) Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Detach the 3 claws and remove the spiral cable.
  
  Fig 3: Identifying Spiral Cable Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002