Side Airbag Sensor: Removal
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION
).
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- REMOVE FRONT DOOR SCUFF PLATE LH (See REMOVAL )
- REMOVE REAR DOOR SCUFF PLATE LH (See REMOVAL )
- REMOVE CENTER PILLAR GARNISH LOWER LH (See REMOVAL )
- REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH
- Disconnect the connector.
- Remove the bolt and sensor.