LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Supplemental Restraint System) >> Airbag System >> DTC B1800/51 Short in Driver Side Squib Circuit; DTC B1801/51 Open in Driver Side Squib Circuit; DTC B1802/51 Short to GND in Driver Side Squib Circuit; DTC B1803/51 Short to B+ in Driver Side Squib Circuit >> Description

DTC B1800/51 Short in Driver Side Squib Circuit; DTC B1801/51 Open in Driver Side Squib Circuit; DTC B1802/51 Short to GND in Driver Side Squib Circuit; DTC B1803/51 Short to B+ in Driver Side Squib Circuit: Description

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

The driver side squib circuit consists of the center airbag sensor, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when the deployment conditions are met.

These DTCs are recorded when a malfunction is detected in the driver side squib circuit.

DTC TROUBLE DETECTION CONDITION

DTC No. DTC Detection Condition Trouble Area
B1800/51 Center airbag sensor receives a line short signal 5 times in the driver side squib circuit during primary check.
  • Instrument panel wire
  • Spiral cable
  • Steering pad (Driver side squib)
  • Center airbag sensor
B1801/51 Center airbag sensor receives an open signal in the driver side squib circuit for 2 seconds.
  • Instrument panel wire
  • Spiral cable
  • Steering pad (Driver side squib)
  • Center airbag sensor
B1802/51 Center airbag sensor receives a short to ground signal in the driver side squib circuit for 0.5 seconds.
  • Instrument panel wire
  • Spiral cable
  • Steering pad (Driver side squib)
  • Center airbag sensor
B1803/51 Center airbag sensor receives a short to B+ signal in the driver side squib circuit for 0.5 seconds.
  • Instrument panel wire
  • Spiral cable
  • Steering pad (Driver side squib)
  • Center airbag sensor