Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CENTER AIRBAG SENSOR ASSEMBLY

Fig 1: Identifying Center Airbag Sensor Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Turn the ignition switch OFF.
2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
4. Turn the ignition switch ON, and wait for at least 60 seconds.
5. Clear the DTCs (see DTC CHECK / CLEAR ).
6. Turn the ignition switch OFF.
7. Turn the ignition switch ON, and wait for at least 60 seconds.
8. Check the DTCs (see DTC CHECK / CLEAR ).
  OK:
  
  DTC B1000/31 is not output.
NG: REPLACE CENTER AIRBAG SENSOR ASSEMBLY

OK: USE SIMULATION METHOD TO CHECK