Data List / Active Test
- Data List
Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Warm up the engine.
- Ignition switch off.
- Connect Techstream to the DLC3.
- Turn the ignition switch ON.
- Turn the tester on.
- Enter the following menus:
- for Combination Meter: Body Electrical / Combination Meter / Data List.
- for ABS/TRAC/VSC: Chassis / ABS/VSC/TRAC / Data List.
- for Engine and ECT: Powertrain / Engine and ECT / Data List.
- for Main Body: Body Electrical / Main Body / Data List.
- Check values by referring to the table below.
Combination Meter:
MEASUREMENT ITEM/RANGE CHARTTester Display Measurement Item/Range Normal Condition Diagnostic Note Tail Cancel SW Tail cancel switch is OFF/ON OFF: Turn the light control rheostat knob is not fully downwards - ON: Turn the light control rheostat knob fully upwards - ODO/TRIP Change SW ODO/TRIP switch is OFF/ON OFF: Switch is released - ON: Switch is pushed - P-Seatbelt Buckle SW Front passenger buckle switch is OFF/ON OFF: Seat belt is fastened - ON: Seat belt is unfastened - Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed (When driving) - Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm Almost same at the meter rpm (When engine is running) - Coolant Temperature Engine coolant temperature: 0°C (32°F) to 127.5°C (261.5°F) After warming up: 80 to 95°C (176 to 203°F) - Oil Level Switch Oil level switch is OFF/ON OFF: Washer level is not low - ON: Washer level is low - +B Voltage Value Battery voltage/Min.: 0 V, Max.: 25.5 V 10 to 14 V - Integrated value for Oil Maintenance ((1)) Oil maintenance warning value: Min.: 0, Max. 25500 (mile) The running distance after performing oil maintenance resetting procedure is displayed If the value is 5000 (mile) or more, perform oil maintenance resetting procedure after changing the oil Fuel Input Fuel input signal Min.: 0, Max. 127.5 Fuel gauge indicates (E): 33 - Fuel gauge indicates (3/4): 98 Fuel gauge indicates (1/2): 144 - Fuel gauge indicates (1/4): 179 Fuel gauge indicates (F): 206 - Ambient Temperature Outside temperature: Min.: -40°C (-40°F) to 50°C (122°F) Almost same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F) Rheostat value Light Control Rheostat/Min.: 0%, Max.: 100% Light control rheostat switch is Dark (0%) → Bright (100%) - Quantity of Outside Light Quantity of outside light/Min.: 0%, Max.: 100% Outside light is Dark (0%) → Bright (100%) - Communication ECM/Meter DTC 1 to 3 Communication error: not occurred/occurred Unrec: No Error has occurred - Rec: Error has occurred - ECM ODO (History 1 to 3) Distance when DTC is output Min.: 0, Max.: 999999 - - Communication ABS/Meter DTC 1 to 3 Communication error: not occurred/occurred Unrec: No Error has occurred - Rec: Error has occurred - ABS/VSC ODO (History 1 to 3) Distance when DTC is output Min.: 0, Max.: 999999 - - Seatbelt Warning Buzzer The condition of the seat belt warning buzzer ON: The driver side seat belt warning buzzer sounds at the vehicle speed is 20 km/h (12 mph) or more when the driver side seat belt is unfastened - OFF: The driver side seat belt warning buzzer does not sound at the vehicle speed is 20 km/h (12 mph) or more when the driver side seat belt is unfastened - Number of Trouble Code The number of the DTC which is currently output 0 - (1) for U.S.A.
- Active Test
Using Techstream to perform Active Tests allows the relay, actuator, and other items to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Test.
- Connect Techstream to the DLC3.
- Turn the ignition switch ON.
- Turn the tester on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the operation by referring to the table below.
Combination Meter:
CONTROL RANGE CHARTTester Display Test Part Control Range Diagnostic Note Speed Meter Operation Speedometer 0,40, 80, 120 mph ((1)) - 0, 40, 80, 120, 160, 200, 240 km/h ((2)) - Tacho Meter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) - Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL Confirm that the vehicle is stopped, engine idling Water Temperature Meter Operation Engine coolant temperature receiver gauge Low, Normal, High Confirm that the vehicle is stopped, engine idling A/T Indicator Operation 1 A/T shift indicator light A/T shift indicator light D, N, R, P is OFF/ON Confirm that the vehicle is stopped, engine idling Meter Display 1 Multi-information display AH the dots in the multi-information display OFF/ON Confirm that the vehicle is stopped, engine idling Meter Display 1 A/T shift indicator display The segments in the A/T shift indicator display OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Airbag Airbag warning light SRS warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Front Passenger Side Seat Belt Front passenger side seat belt warning light Front passenger side seat belt warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Driver Side Seat Belt Driver side seat belt warning light Driver side seat belt warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp ABS ABS warning light ABS warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Charge Charge warning light Charge warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Slip Slip indicator light Slip indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Beam Hi-beam indicator light Hi-beam indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Head ((1)) Head indicator light Head indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Tail ((2)) Tail indicator light Tail indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Fr FOG Front fog indicator light Front fog indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Driver Side Door Open Open door warning light Open door warning light is OFF/ ON Confirm that the vehicle is stopped, engine idling Front Passenger Side Door Open Open door warning light Open door warning light is OFF/ ON Confirm that the vehicle is stopped, engine idling Indicat. Rear Door RH Open Open door warning light Open door warning light is OFF/ ON Confirm that the vehicle is stopped, engine idling Indicat. Rear Door LH Open Open door warning light Open door warning light is OFF/ ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Back Door Open Open door warning light Open door warning light is OFF/ ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Fuel Low fuel warning light Fuel level warning light is OFF/ON Confirm that the vehicle is stopped, engine idling A/T Oil Temperature Operation A/T fluid temperature indicator light A/T fluid temperature warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Cruise Cruise indicator light Cruise indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Lamp Brake Brake warning light Brake warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. EPS EPS warning light EPS warning light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Oil Maintenance Oil replacement reminder light Oil replacement reminder light is OFF/ON Confirm that the vehicle is stopped, engine idling Master Warning Master caution indicator light Master caution indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Downhill Assist Control Downhill assist control indicator light Downhill assist control indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. VSC VSC indicator light VSC off indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling 4WD Warning Indicator 4WD indicator light 4WD indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling Indicat. Auto LSD Auto LSD indicator light Auto LSD indicator light is OFF/ ON Confirm that the vehicle is stopped, engine idling Indicat. 4WD Lock 4WD lock indicator light 4WD lock indicator light is OFF/ ON Confirm that the vehicle is stopped, engine idling (1) for U.S.A. (2) except for U.S.A.