Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CONFIRM DTC OUTPUT
- Connect the Techstream to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Clear the stored DTCs.
- Start the engine and wait for at least 60 seconds.
- Check for DTCs.
Result
RESULT REFERENCEResult Proceed to DTC output A DTC not output B
B: SYSTEM IS OK
A:GO TO CAN COMMUNICATION SYSTEM