Rear Door Speaker: Removal

HINT:

• Use the same procedures for the RH side and LH sides.
• The procedures listed below are for the LH side.

1. REMOVE DOOR ASSIST GRIP COVER LH 
2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH 
3. REMOVE REAR DOOR ARMREST BASE PANEL UPPER LH  (See DISASSEMBLY )
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH  (See DISASSEMBLY )
5. REMOVE REAR NO. 1 SPEAKER ASSEMBLY 
   1. Disconnect the connector.
   2. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.
      NOTE:

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
      • Be careful as the cut rivet will be very hot.
        Fig 1: Drilling Out Rivet Heads Using Drill

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Continue drilling and push out the remaining rivet fragments.
   4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.