Rear Door Speaker: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH sides.
The procedures listed below are for the LH side.

INSTALL REAR NO. 1 SPEAKER ASSEMBLY
1. Using an air riveter or hand riveter, install the speaker with 3 new rivets.
  
  Fig 1: Installing Rear No. 1 Speaker Rivets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    
    Fig 2: Precaution For Prying Rivet With Riveter
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Confirm that the rivets are seated properly against the speaker.
    Do not tilt the riveter when installing the rivet to the speaker.
    
    Do not leave any space between the rivet head and speaker.
    
    Fig 3: Identifying Rivets Installation
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.
2. Connect the connector.
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (See REASSEMBLY )
INSTALL REAR DOOR ARMREST BASE PANEL UPPER LH (See REASSEMBLY )
INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
INSTALL DOOR ASSIST GRIP COVER LH