Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

After the inspection is completed, clear the DTCs.

DISC CLEANING
1. Disc cleaning
  1. If dirt is on the disc surface, wipe it with a soft cloth from inside to outside in a radial direction.
    NOTE: Do not use a conventional record cleaner or antistatic preservative.
    
    Fig 1: Cleaning Disc Surface With Soft Dry Cloth
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CHECK DISC
1. Check that the disc is not deformed or cracked.
  OK: No deformation or cracks on the disc.
  
  Fig 2: Checking Disc For Deformed Or Cracked
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NG: DISC IS FAULTY

OK: Go to Next Step
REPLACE DISC WITH ANOTHER AND RECHECK
1. Replace the disc with another and recheck.
  1. Replace the disc with a normal one.
  2. Clear DTC (see DTC CHECK / CLEAR ).
  3. Recheck DTCs and check if the same trouble occurs again.
    OK: Malfunction disappears.
NG: REPLACE RADIO RECEIVER ASSEMBLY

OK: END