REAR SEAT INNER BELT ASSEMBLY (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR SEAT INNER BELT ASSEMBLY
1. for RH Side (60/40 Split Seat Type):
  1. Install the rear seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    NOTE:
    Install the anchor plate with the arrow mark facing forward.
    
    Do not place the anchor plate over the locating mark area of the floor panel.
    
    Fig 1: Locating Rear Seat Inner Belt Bolt And Arrow Mark
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. for LH Side:
  1. Install the rear seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    NOTE:
    Install the anchor plate with the arrow mark facing forward.
    
    Do not place the anchor plate over the locating mark area of the floor panel.
INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY
1. for 60/40 Split Seat Type:
  1. Install the rear seat cushion cover pad (See INSTALLATION ).
2. for Fixed Seat Type:
  1. Install the rear seat cushion cover pad INSTALLATION .
    
    Fig 2: Locating Rear Seat Inner Belt Bolt And Arrow Mark
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002