REAR SEAT INNER BELT ASSEMBLY (for Hatchback LH Side): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always use "Torx" socket wrench E10 when removing the rear seat.

REMOVE NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See REMOVAL )
REMOVE NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See REMOVAL )
REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type) (See REMOVAL )
REMOVE REAR SEAT INNER BELT ASSEMBLY
1. for 60/40 Split Seat Type:
  1. Using "Torx" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.
    
    Fig 1: Locating Rear Seat Cushion Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Remove the belt from the band.
  3. Remove the bolt and the rear seat inner belt.
    
    Fig 2: Locating Rear Seat Inner Belt Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. for Hold Down Seat Type:
  1. Remove the bolt and the rear seat inner belt.