REAR SEAT INNER BELT ASSEMBLY (for Hatchback LH Side): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always use "Torx" socket wrench E10 when installing the rear seat.

Fig 1: Locating Rear Seat Inner Belt Bolt

INSTALL REAR SEAT INNER BELT ASSEMBLY
1. for 60/40 Split Seat Type:
  1. Install the rear seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    
    NOTE: Do not place the anchor plate over the convex area of the rear seat back frame.
  2. Install the belt into the band.
    
    Fig 2: Locating Rear Seat Inner Belt With Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Install the rear seat cushion.
  4. Using "Torx" socket wrench E10, tighten the 3 bolts in the sequence shown in the illustration.
    Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
    
    Fig 3: Locating Rear Seat Cushion Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. for Hold Down Seat Type:
  1. Install the rear seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    NOTE:
    Install the anchor plate with the arrow mark facing forward.
    
    Do not place the anchor plate over the locating mark area of the floor panel.
INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type) INSTALLATION

Fig 4: Locating Rear Seat Inner Belt Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002