REAR CENTER SEAT INNER BELT ASSEMBLY (for Hatchback RH Side): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always use "Torx" socket wrench E10 when installing the rear seat.

Fig 1: Locating Rear Seat Inner Belt Bolt

INSTALL REAR CENTER SEAT INNER BELT ASSEMBLY
1. for 60/40 Split Seat Type:
  1. Install the rear center seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    
    NOTE: Do not place the anchor plate over the convex area of the rear seat back frame.
    
    Fig 2: Locating Rear Center Seat Inner Belt With Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. for Hold Down Seat Type:
  1. Install the rear center seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    NOTE:
    Install the anchor plate with the arrow mark facing forward.
    
    Do not place the anchor plate over the locating mark area of the floor panel.
INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type) INSTALLATION
INSTALL DECK FLOOR BOX (for 60/40 Split Seat Type)
HINT:

Use the same procedure as for the RH side (See INSTALLATION ).
INSTALL DECK BOARD SUB-ASSEMBLY (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (for 60/40 Split Seat Type) (See INSTALLATION )

Fig 3: Locating Rear Seat Inner Belt Bolt And Arrow Mark
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002