FRONT SEAT INNER BELT ASSEMBLY (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) PRECAUTION .

NOTE: Always use "Torx" socket wrench E10 when installing the front seat.

HINT:

The procedure described below is for the driver side. Use the same procedure for both the front passenger and drive sides, unless otherwise specified.

Fig 1: Measuring Resistance Between Terminals

INSTALL FRONT SEAT INNER BELT ASSEMBLY
1. Install the front seat inner belt with the nut.
  Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
  
  NOTE: Do not place the front seat inner belt over the convex areas of the front seat adjuster frame.
2. Install the wire harness into the claw of the front seat cushion inner shield.
  
  Fig 2: Locating Front Seat Inner Belt With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. for Driver Side:
  1. Install the 2 clamps.
  2. Install the connector.
  3. Connect the seat position sensor connector.
    
    Fig 3: Identifying Clip
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. for Front Passenger Side:
  1. Install the 2 clamps.
  2. Install the connector.
INSTALL FRONT SEAT ASSEMBLY INSTALLATION
INSTALL FRONT SEAT HEADREST ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
DIAGNOSIS SYSTEM

Fig 4: Identifying Clip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002