FRONT SEAT INNER BELT ASSEMBLY (for Hatchback): Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT SEAT INNER BELT ASSEMBLY

for Driver Side:

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Condition	Specified Condition
3 - 4	Tongue plate fastened	10 kΩ or higher
3 - 4	Tongue plate released	Below 1 Ω

If the result is not as specified, replace the front seat inner belt.

Fig 1: Measuring Resistance Between Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for Front Passenger Side:

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Condition	Specified Condition
1 - 2	Tongue plate fastened	10 kΩ or higher
1 - 2	Tongue plate released	Below 1 Ω

If the result is not as specified, replace the front seat inner belt.