Rear Axle Hub And Bearing: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE REAR WHEEL
REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (See REMOVAL )
DISCONNECT SKID CONTROL SENSOR WIRE (w/ ABS)
1. Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.
  NOTE: Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.
  
  Fig 1: Identifying Skid Control Sensor Wire Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
1. Remove the 4 bolts and remove the axle hub and bearing from the axle beam.
  NOTE: Suspend the backing plate with a piece of rope.
  
  Fig 2: Identifying Axle Hub & Bearing Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002