Front Stabilizer Bar: Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT STABILIZER LINK ASSEMBLY
1. As shown in Fig 1, flip the ball joint stud back and forth 5 times before installing the nut.
2. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
  Torque: 1.0 N.m (10 kgf*cm, 8.9 in.*lbf) or less
3. Check for any cracks and grease leakage on the ball joint dust cover.
  
  Fig 1: Inspecting Front Stabilizer Link Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002