Fuel Sender Gauge Assembly (For Sedan): Installation
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FUEL SENDER GAUGE ASSEMBLY
- Install the fuel sender gauge onto the fuel suction with pump and gauge tube.
- Connect the fuel sender gauge connector.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (see INSTALLATION )
- INSTALL FUEL PUMP GAUGE RETAINER (see INSTALLATION )
- CONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY (see INSTALLATION )
- CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY (see INSTALLATION )
- INSTALL REAR FLOOR SERVICE HOLE COVER (see INSTALLATION )
- INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (see INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- CHECK FOR FUEL LEAK (see PRECAUTION )