LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Fuel System) >> Fuel Sender Gauge Assembly (For Hatchback) >> Installation

Fuel Sender Gauge Assembly (For Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Install the fuel sender gauge onto the fuel suction with pump and gauge tube.
      2. Fig 1: Identifying Fuel Sender Gauge Onto Fuel Suction
      G04833464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the fuel sender gauge connector.
      3. Fig 2: Identifying Fuel Sender Gauge Connector
      G04504577Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY  (see INSTALLATION )
  3. INSTALL FUEL PUMP GAUGE RETAINER  (see INSTALLATION )
  4. CONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY  (see INSTALLATION )
  5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY  (see INSTALLATION )
  6. INSTALL REAR FLOOR SERVICE HOLE COVER  (see INSTALLATION )
  7. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type)  (see INSTALLATION )
  8. INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (see INSTALLATION )
  9. INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (see INSTALLATION )
  10. INSTALL DECK FLOOR BOX (for 60/40 Split Seat Type)  (see INSTALLATION )
  11. INSTALL DECK BOARD SUB-ASSEMBLY (for 60/40 Split Seat Type)  (see INSTALLATION )
  12. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (for 60/40 Split Seat Type)  (see INSTALLATION )
  13. INSTALL REAR SEAT CUSHION COVER PAD (for Hold Down Seat Type)  (see INSTALLATION )
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  15. CHECK FOR FUEL LEAK  (see PRECAUTION )
scientia non olet · About LEMON Manuals