Fuel Pump: Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FUEL SENDER GAUGE ASSEMBLY
1. Disconnect the connector of the fuel sender gauge.
  
  Fig 1: Locating Fuel Sender Gauge Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Release the lock and slide the fuel sender gauge to remove it.
  
  Fig 2: Locating Fuel Sender Gauge
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FUEL PUMP
1. Disconnect the connector of the fuel pump harness.
  
  Fig 3: Locating Connector Of Fuel Pump Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the fuel pump filter hose.
  
  Fig 4: Locating Fuel Pump Filter Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump.
  
  Fig 5: Identifying Fuel Filter & Fuel Pump Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disengage the 2 claws and remove the fuel suction support.
  
  Fig 6: Identifying Fuel Suction Support Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump filter and fuel pump from the fuel filter.
  NOTE:
  - Do not damage the fuel pump filter.
  - Do not remove the suction filter.
  - Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.
  Fig 7: Locating Fuel Pump Filter Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Disconnect the fuel pump harness.
  
  Fig 8: Locating Fuel Pump Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the O-ring.
  
  Fig 9: Locating O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002