LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Clutches Manual & Hydraulic) >> Clutch Unit >> Removal

Clutch Unit: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE MANUAL TRANSAXLE ASSEMBLY (See  REMOVAL  ) 
  2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY 
    1. Remove the clutch release fork with the clutch release bearing from the manual transaxle.
  3. REMOVE CLUTCH RELEASE FORK BOOT 
  4. REMOVE CLUTCH RELEASE BEARING ASSEMBLY 
    1. Remove the clutch release bearing from the clutch release fork.
  5. REMOVE RELEASE BEARING HUB CLIP 
  6. REMOVE RELEASE FORK SUPPORT 
    1. Remove the release fork support from the manual transaxle.
  7. REMOVE CLUTCH COVER ASSEMBLY 
    1. Align the matchmark on the clutch cover assembly with the one on the flywheel.
    2. Loosen each set bolt one turn at a time until the spring tension is released.
    3. Remove the set bolts and pull off the clutch cover.
      NOTE: Do not drop the clutch disc.
      Fig 1: Locating Matchmark On Clutch Cover Assembly
      G04831608Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE CLUTCH DISC ASSEMBLY 
scientia non olet · About LEMON Manuals