Clutch Release Cylinder: Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL RELEASE CYLINDER BLEEDER PLUG
Torque: 8.3 N.m (85 kgf*cm, 73 in.*lbf)
INSTALL CLUTCH RELEASE CYLINDER KIT
1. Install the bleeder plug cap onto the bleeder plug.
2. Install a new spring onto the cylinder body.
3. Coat the parts with lithium soap base glycol grease, as shown in Fig 1.
4. Install the piston onto the cylinder body.
  NOTE: Do not damage the inside of the cylinder body.
5. Install the push rod onto the cylinder body.
6. Install the boot onto the cylinder body.
  
  Fig 1: Coating Parts With Lithium Soap Base Glycol Grease
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002