Clutch Pedal Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CLUTCH START SWITCH ASSEMBLY
1. Install the clutch start switch with the nut.
  Torque: 16 N.m (160 kgf*cm, 12 ft.*lbf)
  
  NOTE: Insert the protrusion of the clutch start switch into the hole in the clutch pedal support.
2. Connect the clutch start switch connector.
Fig 1: Locating Clutch Start Switch Bracket Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT CLUTCH START SWITCH ASSEMBLY (See ON-VEHICLE INSPECTION )