Differential Oil Seal: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION CASE OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, install the new oil seal.
  SST 09309-37010
  
  Drive in depth:
  
  9.6 to 10.2 mm (0.378 to 0.402 in.)
  
  NOTE: Do not damage the oil seal lip.
  
  Fig 1: Identifying SST, Hammer & New Transmission Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSAXLE CASE OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, install the new oil seal.
  SST 09710-26011 (09710-05061)
  
  Drive in depth:
  
  1.6 to 2.2 mm (0.063 to 0.087 in.)
  
  NOTE: Do not damage the oil seal lip.
  
  Fig 2: Identifying SST, Hammer & New Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT AXLE ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT AXLE ASSEMBLY RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL TIE ROD END SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH (See INSTALLATION )
INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL SPEED SENSOR FRONT LH (w/ ABS) (See INSTALLATION )
INSTALL SPEED SENSOR FRONT RH (w/ ABS)
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT AXLE HUB LH NUT (See INSTALLATION )
INSTALL FRONT AXLE HUB RH NUT
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT WHEELS
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
ADD TRANSAXLE OIL
INSPECT AND ADJUST TRANSAXLE OIL (See ON-VEHICLE INSPECTION )
INSPECT ABS SPEED SENSOR SIGNAL (See TEST MODE PROCEDURE )
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT (See ADJUSTMENT )
CHECK FOR TRANSAXLE OIL LEAKAGE