Rear Brake Flexible Hose: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR BRAKE FLEXIBLE HOSE
1. Install the flexible hose with the 2 new clips onto the axle beam.
2. Using SST, install the 2 brake tubes onto the flexible hose.
  SST 09023-00100
  
  Torque: for use without SST
  
  15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  for use with SST
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 1: Separating Brake Tubes
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  - Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
  - This torque value is effective when SST is parallel to a torque wrench.
FILL RESERVOIR WITH BRAKE FLUID (See BLEEDING )
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK FOR BRAKE FLUID LEAKAGE
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)