Front Brake Flexible Hose: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT BRAKE FLEXIBLE HOSE
1. Install the flexible hose with the union bolt and a new gasket.
  Torque: 30 N*m (310 kgf*cm, 22 ft.*lbf)
  
  HINT:
  
  Install the flexible hose lock securely into the lock hole in the disc brake cylinder.
  
  Fig 1: Separating Brake Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/ ABS:
  1. Install the flexible hose and speed sensor with the bolt.
    Torque: 29 N*m (300 kgf*cm, 22 ft.*lbf)
    
    NOTE: Install the flexible hose and speed sensor without twisting them.
3. w/o ABS:
  1. Install the flexible hose with the bolt.
    Torque: 29 N*m (300 kgf*cm, 22 ft.*lbf)
    
    NOTE: Install the flexible hose without twisting it.
4. Install a new clip.
5. Using SST, install the brake tube.
  SST 09023-00100
  
  Torque: for use without SST
  
  15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  for use with SST
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
  - This torque value is effective when SST is parallel to a torque wrench.
FILL RESERVOIR WITH BRAKE FLUID (See BLEEDING )
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK FOR BRAKE FLUID LEAKAGE
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)