Purge Valve: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PURGE VSV
1. Install the purge VSV.
2. Engage the clip and connect the purge VSV connector.
  
  Fig 1: Locating Purge VSV Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL VAPOR FEED HOSE NO. 2
1. Connect fuel vapor feed hose No. 2.
  
  Fig 2: Locating Fuel Vapor Feed Hose No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL VAPOR FEED HOSE NO. 1
1. Connect fuel vapor feed hose No. 1.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Locating Fuel Vapor Feed Hose No. 1
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002