Section 206 (Emission Control System (1ZZ-FE)): Canister: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE CANISTER
1. Disconnect the connector.
  
  Fig 1: Locating Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the purge line hose.
3. Disconnect the air inlet line hose from the leak detection pump.
4. Disconnect the vent line hose from the canister.
  
  Fig 2: Locating Purge Line Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 3 bolts and the canister assembly.
  
  Fig 3: Locating Canister Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002