Section 206 (Emission Control System (1ZZ-FE)): Canister: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CANISTER
1. Install the canister with the 3 bolts.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  Fig 1: Locating Canister Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the vent line hose to the canister.
3. Connect the air inlet line hose to the leak detection pump.
4. Connect the purge line hose.
  
  Fig 2: Locating Vent Line Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Locating Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002