Cooling Fan Resistor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COOLING FAN RESISTOR
1. Install the cooling fan resistor with the 2 bolts.
  Torque: 5.1 N*m (52 kgf*cm, 45 in.*lbf)
2. Connect the cooling fan resistor connector.
Fig 1: Locating Cooling Fan Resistor Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER LINER LH (See INSTALLATION )
INSTALL FRONT WHEEL LH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)