Oil Pump: Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL OIL PUMP RELIEF VALVE
1. Coat the oil pump relief valve with engine oil and insert the oil pump relief valve and oil pump relief valve spring into the oil pump cover.
2. Install the oil pump relief valve plug.
  Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
  
  Fig 1: Identifying Oil Pump Relief Valve Plug & Oil Pump Relief Valve Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OIL PUMP ROTOR SET
1. Coat the oil pump rotor set with engine oil and place it into the oil pump body with the marks facing the oil pump cover side.
  
  Fig 2: Identifying Oil Pump Rotor Set Mark
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OIL PUMP COVER
1. Install the oil pump cover with the 2 bolts and 3 screws.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf) for bolt 10 N*m (105 kgf*cm, 7.6 ft.*lbf) for screw
  
  Fig 3: Locating Oil Pump Cover Bolts & Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002