CONDENSER (for Hatchback): Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COOLER DRYER
1. Using pliers, install the cooler dryer onto the modulator.
  
  Fig 1: Installing Cooler Dryer Into Modulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply sufficient compressor oil to a new O-ring and the fitting surface of the cap.
  Compressor oil: ND-OIL 8 or the equivalent
  
  Fig 2: Compressor Oil Specifications
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a 14 mm straight hexagon wrench, install the cap onto the cooler condenser core.
  Torque: 2.9 N*m (30 kgf*cm, 25 in.*lbf)
  
  Fig 3: Removing Cap From Modulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002