COMPRESSOR AND PULLEY (for 1NZ-FE): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See ON-VEHICLE INSPECTION )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER RH
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE
1. Remove the bolt and disconnect the suction hose.
2. Remove the O-ring from the suction hose.
  NOTE: Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
  
  Fig 1: Disconnecting No. 1 Cooler Refrigerant Suction Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
1. Remove the bolt and disconnect the discharge hose.
2. Remove the O-ring from the discharge hose.
  NOTE: Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
  
  Fig 2: Disconnecting No. 1 Cooler Refrigerant Discharge Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMPRESSOR AND PULLEY
1. Disconnect the connector.
2. Remove the 4 bolts and compressor.
  
  Fig 3: Identifying Bolts And Compressor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002