BLOWER UNIT (for Sedan): Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CLEAN AIR FILTER
1. Install the clean air filter into the blower assembly.
  NOTE: Install the clean air filter with its UP mark oriented in the correct direction.
  
  Fig 1: Installing Clean Air Filter Into Blower Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR FILTER CASE
1. Insert the rib of the air filter case into the blower assembly.
  NOTE: Install the air filter case with its UP mark oriented in the correct direction.
2. Pinch portion A to engage the claw and install the air filter case.
  
  Fig 2: Inserting Rib Of Air Filter Case Into Blower Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BLOWER RESISTOR
1. Install the blower resistor with the 2 screws.
  
  Fig 3: Identifying Screws And Blower Resistor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BLOWER MOTOR
1. Install the blower motor with the 3 screws.
  
  Fig 4: Identifying Blower Motor With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY
1. Engage the 3 claws and install the air inlet damper control cable.
  
  Fig 5: Identifying Claws For Air Inlet Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY
1. Engage the 2 claws and install the air duct.
  
  Fig 6: Identifying Claws And For Air Duct
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002