BLOWER UNIT (for Sedan): Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
1. Disengage the 2 claws and remove the air duct.
  
  Fig 1: Identifying Claws And For Air Duct
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY
1. Disengage the 3 claws and remove the air inlet damper control cable.
  
  Fig 2: Identifying Claws For Air Inlet Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER MOTOR
1. Remove the 3 screws and the blower motor.
  
  Fig 3: Identifying Screws And Blower Motor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER RESISTOR
1. Remove the 2 screws and the blower resistor.
  
  Fig 4: Identifying Screws And Blower Resistor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR FILTER CASE
1. Pinch portion A to disengage the claw and remove the air filter case.
  
  Fig 5: Removing Air Filter Case
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLEAN AIR FILTER
1. Remove the clean air filter from the blower assembly.
  
  Fig 6: Identifying Clean Air Filter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002