ENGINE HOOD COURTESY SWITCH (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE HOOD LOCK ASSEMBLY
1. Disconnect the connector and the harness clamp.
2. Remove the 3 bolts.
  
  Fig 1: Locating Harness Clamp Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the hood lock control cable, then remove the hood lock.
  
  Fig 2: Locating Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002