ENGINE HOOD COURTESY SWITCH (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HOOD LOCK ASSEMBLY
1. Connect the hood lock control cable.
  
  Fig 1: Locating Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the hood lock with the 3 bolts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
3. Connect the connector and the harness clamp.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)