LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Audio System & Visual System) >> REAR PACKAGE TRAY SPEAKER (for Sedan) >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. REAR SPEAKER ASSEMBLY 

    HINT:

    Remove interior parts so that the rear speaker can be seen.

    1. Check the installation.

      OK: The speaker is securely installed. 

      If the result is not as specified, reinstall the rear speaker.

    2. Visually check the speaker.

      OK: The cone paper of the speaker is not torn. 

      If the result is not as specified, replace the rear speaker.

    3. Check the resistance.
      1. Disconnect the speaker connector.
      2. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance 

        RESISTANCE SPECIFICATION

        Tester Connection Specified Condition
        1-2 Approximately 4 Ω

        If the result is not as specified, replace the rear speaker.

        Fig 1: Measuring Resistance Between Rear Speaker Terminals
        G04833669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals