REAR DOOR SPEAKER (for Hatchback 5 Door): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

INSTALL REAR SPEAKER ASSEMBLY
1. Using an air riveter or hand riveter, install the rear speaker assembly onto the front door panel with 3 new strike rivets.
  HINT:
  
  Install the new strike rivets in the order shown in the illustration.
  
  Fig 1: Installing Strike Rivets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    
    Fig 2: Precaution For Installation Of Rivets (1 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Confirm that the rivets are seated properly against the speaker.
  - Do not tilt the riveter when installing the rivet onto the speaker.
  - Do not leave any space between the rivet head and speaker.
    
    Fig 3: Precaution For Installation Of Rivets (2 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.
    
    Fig 4: Precaution For Installation Of Rivets (3 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the speaker connector.
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
1. w/ Power Window:
  1. Install the rear door trim board sub-assembly REASSEMBLY .
2. w/o Power Window:
  1. Install the rear door trim board sub-assembly (See REASSEMBLY ).
INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)