On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT REAR SPEAKER ASSEMBLY

HINT:

Remove interior parts so that the rear speaker can be seen.

Check the speaker installation.
OK: The speaker is securely installed.

If the result is not as specified, reinstall the rear speaker.
Visually check the speaker.
OK: The cone paper of the speaker is not torn.

If the result is not as specified, replace the rear speaker.

Check the speaker resistance.

Disconnect the rear speaker connector.

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Specified Condition
1-2	Approximately 4 Ω

If the result is not as specified, replace the rear speaker.

Fig 1: Identifying Front No 1 Speaker Connectors