LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Audio System & Visual System) >> FRONT NO. 1 SPEAKER (for Hatchback) >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FRONT NO. 1 SPEAKER 

    HINT:

    Remove interior parts so that the front No. 1 speaker can be seen.

    1. Check the speaker installation.

      OK: The speaker is securely installed. 

      If the result is not as specified, reinstall the front No. 1 speaker.

    2. Visually check the speaker.

      OK: The cone paper of the speaker is not torn. 

      If the result is not as specified, replace the front No. 1 speaker.

    3. Check the speaker resistance.
      1. Disconnect the speaker connector.
      2. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance 

        RESISTANCE SPECIFICATION

        Tester Connection Specified Condition
        1-2 Approximately 4 Ω

        If the result is not as specified, replace the front No. 1 speaker.

        Fig 1: Identifying Front No 1 Speaker Connectors
        G04833657Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals