FRONT NO. 1 SPEAKER (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
1. Using an air riveter or hand riveter, install the front No.1 speaker assembly onto the front door panel with 3 new strike rivets.
  HINT:
  
  Install the new strike rivets in the order shown in the illustration.
  
  Fig 1: Installing Strike Rivets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    
    Fig 2: Precaution For Installation Of Rivets (1 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Confirm that the rivets are seated properly against the speaker.
  - Do not tilt the riveter when installing the rivet onto the speaker.
  - Do not leave any space between the rivet head and speaker.
    
    Fig 3: Precaution For Installation Of Rivets (2 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.
    
    Fig 4: Precaution For Installation Of Rivets (3 Of 3)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the speaker connector.
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
1. w/ Power Window:
  1. Install the front door trim board sub-assembly (See REASSEMBLY ).
2. w/o Power Window:
  1. Install the front door trim board sub-assembly (See REASSEMBLY ).
    
    Fig 5: Locating Speaker Connector
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR ARMREST BASE UPPER PANEL
1. w/ Power Window:
  1. Install the front door armrest base upper panel (See REASSEMBLY ).
2. w/o Power Window:
  1. Install the front door armrest base upper panel (See REASSEMBLY ).
INSTALL FRONT DOOR ARMREST COVER (See REASSEMBLY )
INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)